Home > Danelaw Pitched Roofing > FAQS > Roof Jointing

Roof Jointing

Is there a minimum pitch on a Bonding Gutter?

Both the traditional Danelaw mortared type and the Dry Fix Bonding Gutter are designed to work to the minimum recommended pitch of the slates or tiles being used with them.

What is the detail where Dry Fix Bonding Gutter meets at ridge?

This depends on the situation. If the external roof covering is at the same height on either side of the Dry Fix Bonding Gutter, then the central upstand should be cut down at an angle to allow the ridge tile to pass over the joint in the roof.

If the external roof covering is higher on one side of the Dry Fix Bonding Gutter, e.g. tiles on one side, slates on the other or flat tiles on one side and profiled tiles on the other, then the ridge tile cannot be carried over the joint in the roof. In this case the central upstand should be mitre cut on both sides of the roof so that the ridge tiles can butt against it.

In both situations, a saddle should be formed over the joint. This is most easily achieved using a good quality flexible, fully adhesive flashing product such as Fast Flash.

How much should the overlap be when joining Dry Fix Bonding Gutter on a pitch of below 22.5°?

Unsealed overlaps such as this should lap by a minimum of 150mm when measured vertically. This converts to 350mm at this low pitch.

I have the Danelaw Dry Fix Bonding Gutter installed and it is causing the tiles to kick up. How do I rectify this?

The design of the product when fitted on top of the tile or slate battens will cause this effect. It acts in the same way as a swept verge and encourages the water to run away from the roof joint.

Whether using slates, plain tiles or interlocking tiles, the first course at eaves should be the full tile or larger slate cut.

If this is not desirable at low pitches, then Dry Fix Bonding Gutter may be installed with the side flange ribs at the same height or lower than the top surface of the roof battens, providing that it is adequately supported.

When installing Dry Fix Bonding Gutter, should I treat is as the same as a roof edge and increase the number of fixings required?

No, this is not necessary. Where the roof is in the same plane either side of the roof joint, the wind loading is not increased in the same way that it is at the eaves, verge, valleys and ridge.

Do I need to use mortar on your traditional flat Bonding Gutter product?

The slates or tiles should be bedded on either a roof mix mortar or a low shrink, high quality external grade sealant taking care not to use excessive amounts that will spread out and block the side water channels. This is the first line of defence against rainwater and can assist in securing smaller cuts of slate or tile.

The side water channels are designed as a secondary line of defence should water enter the roof covering at this point.


Danelaw merchants stockists pitched roofing products Danelaw merchants stockists pitched roofing products

Danelaw Stockist

We have a comprehensive list of merchants across the UK that stock our Danelaw roofing products. Search using location, and discover a list of stockists in that area with contact information of the branch and your local area Sales Manager, who can help you with any questions you may have.

View Stockist


Download a brochure

Download the Danelaw Brochure or Pocket Product Guide

Need advice?

If you need any advice just contact our dedicated technical team who’ll be glad to help

Want to book a CPD seminar?

You can fill out our online booking form and select the appropriate seminar for you

Share this page on your social networks

Main Hambleside Danelaw logo
Hambleside Danelaw Limited
Long March, Daventry, Northamptonshire, NN11 4NR, UK
+44 (0) 1327 701 900   |   +44 (0) 1327 701 909
iso-certification

© Hambleside Danelaw Limited